The Corrugated profile is sinusoidal and can be used as roofing and cladding material. With its origins dating back to the Victorian era, it is probably the most commonly known sheeting profile used in the world today. The fact that the corrugated profiled sheeting has been around since before the turn of the century proves that this easy to use and effective profile for roofing and wall cladding is here to stay. Classicorr is the traditional and familiar S-Rib profile for roofing and cladding applications. The S-rib is derived from the sinus curve and offers very strong structural properties. The Corrugated profile virtually eliminates oil canning and the sheeting can be factory cranked, curved and bullnosed to various radii depending on customer's requirements.
Product Description and Features:
The corrugated profile is sinusoidal and can be used as both roofing and cladding material. With its origins dating back to the Victorian era, it is probably the most commonly known
sheeting profile used in the world today. The fact that corrugated profiled sheeting has been around since before the turn of the century proves that this easy to use and effective profile for roofing and wall cladding is here to stay.
Corrugated sheets can be factory cranked, curved and bullnosed to a wide range of radii. For further details contact our Technical Department.
Safintra 0.50mm thick, AZ150 Zincal® Classicorr Corrugated roof sheeting, crest-fixed to intermediate timber purlins at 1200mm centres and ridge and eave purlins at 900mm centres, with #12 x 65mm timberfix Fixtite® or Safintra approved hex head self-drilling fasteners. Sheets to be fixed with three fasteners per sheet on intermediate purlins and five fasteners per sheet on ridge and eave purlins.
The sheeting shall be Classicorr Corrugated as manufactured by Safintra. The profile shall be roll-formed with 10.5 sinusoidal crests at 76mm centres, with an effective cover width of 762mm. The crest height shall be 17.5mm and shall be fixed in accordance with the manufacturers recommendations.
Purlin Spacing's are dependent on both downward loading and negative suction loading caused by wind. An engineer should be consulted to calculate the load (kN/m2) for your particular application.
Lengths and Roof Pitch:
When using Corrugated sheeting the recommended minimum roof slope (pitch) for sheets longer than 15m is 15°, and for sheets shorter than 15m the minimum roof slope is 10°.
Classicor Corrugated is pierce fixed to timber or steel supports. This means that fastener screws pass through the sheeting. Always drive the fasteners perpendicular to the sheeting, and in the center of the rib. It is recommended that side laps be stitched at 500mm centers with a #14 x 22mm metalfix stitching fastener. It is further recommended that every second rib is fixed at the eaves, ridges and the apex of the roof. Side and end laps are to be sealed using a suitable butyl product or neutral cure silicone.
Refer to the Fixtite® Fastener section for fixing guidelines.